d&b 5D Amplifier

The 5D is a Class D installation amplifier with flexible power distribution among its four output channels. It uses Digital Signal Processing (DSP) to incorporate loudspeaker-specific configurations for smaller loudspeakers from E-Series, xS-Series, xC- and T-Series, as well as equalization and delay functions. A linear setup is available allowing the amplifier to be used as a linear installation power amplifier.

The amplifier has a dynamic range of 111 dB (Dante input, unweighted) and is designed to drive a selected range of d&b loudspeakers while providing comprehensive management and protection capabilities.

Digital Signal Processing

• Latency analog / Dante input: 1.1 ms / < 3 ms
• Configurations: Selected loudspeakers from E-Series, xS-Series, xC Series, T-Series; Linear setup
• Frequency generator: Pink noise or Sine wave 10 Hz – 20 kHz

Controls and indicators

• Display: LED indicators

Connectors

• Ethernet, Dante Input: 2 x RJ 45, 1 Gbit / 100 Mbit
• GPI: 1 x 6-pin Euroblock 3.5 mm male
• Input / Link ANALOG (A1-A4): 2 x 6-pin Euroblock male, 3.5 mm
• Speaker outputs A/B/C/D: 2 x 4-pin Euroblock 5.08 mm female
• Mains connector: IEC
• FAULT: 1 x 3-pin Euroblock 3.5 mm male

Data (linear setting with subsonic filter)

• Maximum output power per channel (THD+N < 0.5%, all channels driven): CF = 12 dB at 4 / 8 ohms4 x 600 W

Power supply

• Type: Wide range switched mode power supply with active Power Factor Correction (PFC)
• Rated mains voltage: 100 - 240 V, 50 - 60 Hz

Dimensions / weight

• Dimensions (H x W x D): 1 RU x 9.5" x 435 mm/17.1"
• Weight: 4.6 kg (10 lb)